CEfx Power
CEfx Mounting Options
CEfx modules are designed to mount directly into most standard solderless breadboards. However there
are other mounting options if you want a more permanent (soldered) design, or if you want to
use a CEfx module in a Eurorack modular synth rack.
Breadboard Power Strips
If you want a quick and easy way to mount your CEfx modules and you do not intend to do
any circuit breadboarding, breadboard bus strips (such as BKGS-100-ND or BKGS-060-ND) can
be used to connect and mount CEfx modules without a full breadboard. You can make a more permanent
installation by replacing the bus strips with lengths of stripboard soldered into place.
Stripboard/Perfboard
If you plan to mount CEfx modules on standard 0.1 inch stripboard or perfboard, review the
CEfx Power Options page and note the modifications required to properly align the CEfx
power headers.
Standoffs/Companion Boards
Each CEfx module has two divots on the left edge and two more on the right. These allow the
module to be mounted to a base on standoffs or to support parallel-mounted companion boards.
On each side, the mounting holes are 1.0" from the bottom, 1.0" from the top, and 1.9" from each other.
Between the two sides, the mounting holes are a multiple of 0.6 inches depending on the modules (all
CEfx modules are multiples of this width which we refer to as a "cycle").
For example, the CEfx power module is two cycles wide, so the mounting holes are spaced 1.2" apart.
Eurorack
By making your own faceplate and appropriate standoffs, a CEfx module can be mounted in
a standard Eurorack modular system. See also our CEfx Eurorack Power adapter for an easy
way to power the CEfx module in the Eurorack system.
News: Facebook page.
Reviews: Trustpilot
Home
Semiconductors
Articles
CEfx Experimenters Series Modules
About Us
Contact Us
V 11.49